KNOPPO KF3015T Metal Sheet And Tube Fiber Laser Cutter is successfully exported . KF-T dual use fiber laser cutting machine can cut metal sheet and tube , sheet cutting area is 3000*1500mm , 6000*1500mm and other option , tube cutting length is 3m or 6m . And most spare parts is from famous brand , Swizerland Raytools laser head , Japan Fuji servo motor , Japan SMC gas valve , Japan Shimpo reducer and Taiwan rail etc , good quality and 3 years warranty .
Fiber laser cutting machine is popular now , because laser cutting has the advantage over traditional cutting
1. high precision: focusing accuracy of 0.05mm, repeated focusing accuracy of 0.02 mm
2. narrow slit: the laser beam is focused into a small spot, so that the focus to achieve high power density, the mate rial quickly heated to the degree of gasification, evaporation to form a hole. As the beam moves linearly relative to the material, the holes continue to form narrow-width slits. Cutting width is generally 0.10 〜0.20mm.
3 .cutting surface smooth: cutting surface without burr, incision surface roughness generally controlled within Ra12.5.
4 . good cutting quality: non-contact cutting, trimming little affected by heat, the basic no thermal deformation of the workpiece, completely avoid the formation of the material when the red edge cutting, kerf generally do not need secondary processing.
5 . does not damage the workpiece: the laser cutting head will not be in contact with the surface of the material to ensure that no scratches the workpiece.
Contrast with other cutting advantages
1,wire cutting: high precision, piercing difficulties, slow cutting speed. Equipment investment is not big. A device from tens of thousands to tens of thousands or so
2,laser cutting: high precision, speed with a great impact on board thickness, generally less than 10 m/min. Thick plate can not cut (generally 25MM below), equipment into large. Suitable for high-volume processing
3,water cutting: the accuracy is quite high, the speed is quite slow. Not suitable for mass production and processing. Equipment investment is relatively large.
4,plasma cutting: high precision (product verticality is not high), fast, consumables fast. Suitable for high-volume processing. Equipment into the general.
5,flame (oxygen) cutting： precision (thermal deformation large), slow, but can cut a lot of cutting at the same time, suitable for high-volume processing. Equipment into small, cheaper operating costs.
6,Punch： less variety of products more difficult, less obvious advantages of large quantities of products. Thick board cutting difficult. Cost input in general.
7,shearing machine: curved cutting not, straight cut OK, thick plate has difficulty.
Post time: Sep-10-2021